Leon Mk2
Clutch actuation mechanism: repair |
1 - | Pedal |
q | If this has to be removed, first remove the steering column → Running gear, axles, steering; Rep. Gr.48 |
2 - | Rubber stop |
3 - | Hexagonal bolt, 2 Nm |
q | To fit the clutch cable support to the bodywork |
4 - | Support |
5 - | Clutch cable |
q | Checking the working → Chapter |
q | Removing and refitting → Chapter |
6 - | Bellows |
q | Fit in the dashboard |
7 - | Terminal |
q | To fit the clutch cable to the clutch pedal |
8 - | Support |
q | Fit in such a way that the rubber guide -arrow- lies in the receiver hole |
9 - | Rubber stop |
q | Fit in the pedal unit |
10 - | Hexagonal bolt, 25 Nm |
11 - | Hexagonal nut, self-locking, 25 Nm |
q | 5 units |
q | To fit the pedal unit to the servobrake |
12 - | Washer |
13 - | Bearing bushing |
q | For the clutch pedal |
q | Lubricate with -MoS2- grease. |
14 - | Clutch and brake pedal shaft |
15 - | Bearing bushing |
q | To fit to the steering column |
16 - | Bearing bushing |
q | Insert in the bearing bushing ( → Item) and then fit the brake pedal |
17 - | Brake pedal |
18 - | Washer |
19 - | Hexagonal bolt, 25 Nm |
20 - | Clutch pedal |
q | Removing and refitting → Chapter |
21 - | Support |
q | Bolted together with the battery support |
22 - | Gearbox |