Leon Mk2
| Assembly diagram - pedal bracket |
| 1 - | Support |
| q | First remove the steering column before removing the bracket → Running gear, axles, steering; Rep. Gr.48 |
| 2 - | Hexagon bolt |
| q | 25 Nm |
| 3 - | Hexagon nut |
| q | 25 Nm |
| q | Self-locking |
| q | 5 units |
| q | To secure the support block to the brake servo support bolt |
| q | Always renew |
| 4 - | Hexagon nut |
| q | 25 Nm |
| q | Self-locking |
| q | 2 units |
| q | Always renew |
| 5 - | Support |
| 6 - | Bearing bush |
| q | For locating the steering column |
| 7 - | Spring washer |
| q | Removing and fitting → Chapter, Clutch pedal: removing and installing |
| 8 - | Brake and clutch pedal shaft |
| q | Assembly position: the recess -arrow- should be facing the clutch pedal side |
| 9 - | Brake pedal |
| 10 - | Cap |
| 11 - | Counterweight |
| q | Place it to the right of the clutch pedal |
| q | It fits in only one position |
| 12 - | Clutch pedal |
| q | Removing and fitting → Chapter |
| 13 - | Counterweight |
| q | Place it to the left of the clutch pedal |
| q | It fits in only one position |
| 14 - | Retaining clip |
| 15 - | Spring washer |
| q | Removing and fitting → Chapter, Clutch pedal: removing and installing |
| 16 - | Neutral overpass spring |
| q | Removing and fitting → Chapter |
