seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Fitting (clutch cable not tensioned) > < Removing

Leon Mk2

Fitting (clutch cable tensioned)
Fitting (clutch cable tensioned)
–  Pull the clutch cable through the bulkhead and fit the bellows.
–  Lubricate the clutch cable securing/clutch pedal area with -G 052 142 A2- grease.
   
–  Hook the clutch cable to the clutch pedal -arrow- an fit a new plastic tie.
–  Insert the end of the clutch cable into the location on the gearbox, as well as the clutch release lever shaft, without damaging the plastic cable sleeve.
  V30-0387
–  Release the clutch release locking components (the illustration shows the vehicles without counterweights).
  V30-0346
–  Secure the clutch cable to the wire fixing points -arrow-.
  Note!
On securing the clutch cable to its location do not bend, otherwise the automatic adjustment mechanism could stop working properly.
–  Remove the automatic adjustment mechanism tensioning tape.
–  Fit the neutral overpass spring → Chapter
–  Press clutch pedal to the floor at least 5 times.
–  Check clutch cable adjustment → Chapter
  N30-0164

Fitting (clutch cable not tensioned) > < Removing