seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing > < Remove clutch K1 from K3

Leon Mk2

Fit clutches K1 and K3
   
Fit clutches -K1- and -K3-
–  Apply ATF to the O ring.
–  Place the new oil seal on the turbine shaft groove -arrow-.
Fit clutches -K1- and -K3- as follows:
–  Ensure that all tool surfaces are undamaged.
  N38-0022
–  Place tool -U-40100/4- in the press and position clutches -K1- and -K3- on the tool.
–  Insert tool -U-40300/2- between the press and clutch -K3-.
–  Activate the press until the gears are fitted.
  Note!
When clutch -K3- is completely fitted to clutch -K1-, release tension to avoid damaging the clutches.
  E37-0014

Installing > < Remove clutch K1 from K3