| Remove clutch -K1- from -K3- |
| –
| Clutches -K1- and -K3- are snap-fitted one on top of the other. |
| –
| Clutch -K1- must only be removed from clutch -K3- for the cleaning or replacement of one of the clutches. |
| Remove clutches -K1- and -K3- as follows: |
| –
| Ensure that all tool surfaces are undamaged. |
| –
| Place tool -U-40100/4- in the press and position clutches -K1- and -K3- on the tool. |
| –
| Insert tool -U-40300/3- between the press and clutch -K3-. |
| –
| Activate the press until the gears are removed. |
|
|
|
