Leon Mk2
| Ignition system components: removing and installing |
| 1 - | Earth strap |
| 2 - | Connector |
| 3 - | 10 Nm |
| 4 - | Ignition transformer -N152- |
| q | With output stage -N157- |
| q | Checking → Chapter |
| 5 - | Connect anti parasitic |
| q | 0,6…1,4 kΩ |
| 6 - | Protective cap |
| 7 - | Distributor cover |
| q | Verify that there are no cracks or traces of electrical shocks |
| q | Check for wear of the contacts |
| q | Clean before placing |
| q | Check the brushes for wear and ease of movement |
| 8 - | Ignition distributor rotor |
| q | Identification: R1 |
| q | 0,6…1,4 kΩ |
| 9 - | Dustguard |
| 10 - | Cylinder mark 1 |
| 11 - | Ignition distributor with Hall sender -G40- |
| q | Dismantling and assembling → Chapter |
| q | Check and adjust ignition timing → Chapter |
| q | Check the Hall sender → Chapter |
| 12 - | O-ring |
| q | Renew if damaged |
| 13 - | 20 Nm |
| q | Tightening torque influences the functioning of the knock sensor |
| 14 - | Knock sensor 1 -G61-* |
| q | Sensor and connector contacts are gold-plated |
| 15 - | Spark plug, 25 Nm |
| q | Type and electrode gap → Chapter |
| 16 - | Spark plug cap |
| q | 4…6 kΩ |
| 17 - | Ignition cable |
| q | Check for continuity |
