seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Toothed belt: Removing and installing|Install > < Toothed belt: Removing and installing|Installation

Leon Mk2

Remove
Remove
–  Drain the coolant → Chapter.
–  Remove the toothed belt → Chapter.
  Note!
Both rings for the lift hook are located on the cylinderhead; thus, it is necessary to fix an additional support to hold the engine by the block and thus be able to remove the cylinderhead.
   
–  Fit crossbeam -U-30025- as shown and hold the engine in installation position.
–  Carefully raise the engine slightly with the shaft -A-.
  E15-0078
–  Thread -as shown in the illustration- support -T10014- into the threaded hole near the coolant pump in the block Tightening torque: 20 Nm
–  Raise the engine slightly with the shaft -B-, until the shaft -A- has no load.
–  Remove the shaft -A-.
–  Before removing the cylinderhead, drain the fuel with vacuum pump -SAT 1390- with purge tank -SAT 1390/1- in the tandem pump → Chapter; Tandem pump: removing and installing.
  N15-0299
–  Follow the order for loosening the cylinderhead bolts.
  N15-0291

Toothed belt: Removing and installing|Install > < Toothed belt: Removing and installing|Installation