seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Work sequence > < Installing

Leon Mk2

Dynamically checking and adjusting commencement of injection
Dynamically checking and adjusting commencement of injection
  Note!
t  Dynamically checking and correcting commencement of injection is only possible in function 04 “Engine basic setting”.
t  The commencement of injection must always be checked after renewing the toothed belt or loosening the injection pump bolts or toothed belt sprockets and if necessary adjusted.
Special tools and workshop equipment required
   
t  Spanner -U-40072-
  W00-2228
t  Torque wrench -SAT 8010- (20...100 Nm)
t  Fault reader -V.A.G 1551- or vehicle system tester -V.A.G 1552- with cable -V.A.G 1551/3A-
Checking and adjustment conditions
l  Engine basic mechanical settings (timing) OK.
l  Toothed belt tension OK.
  W00-2760

Work sequence > < Installing