Leon Mk2
| Part II |
| For repairs to the clutch → 5-speed manual gearbox 085; Rep. Gr.30. |
| 1 - | Cylinder block |
| q | Dismantling and assembling aluminium cylinder block → Chapter |
| q | Piston and conrod: dismantling and assembling → Chapter |
| 2 - | 50 Nm |
| q | Tightening sequence: |
| Upper right bolt first, then lower right bolt, and bolts on left last (as seen from direction of travel) |
| q | Renew |
| 3 - | Oil filter |
| q | Loosen using a universal filter extractor on the flats -U-40078- |
| q | Tighten by hand |
| q | Note instructions printed on filter when installing |
| 4 - | Support |
| q | For vane pump and alternator |
| q | Vehicles with air conditioner |
| q | Removing and installing compact bracket on vehicles with air conditioning → Heating, air conditioning; Rep. Gr.87 |
| 5 - | 13 Nm |
| q | Loosen and tighten the bolts on the steering wheel side with Allen key -U-40051- |
| 6 - | Sump |
| q | Removing and installing → Chapter |
| 7 - | Oil drain screw, 30 Nm |
| q | With attached seal |
| q | Renew |
| 8 - | 20 Nm + ¼ turn (90º) |
| q | Renew |
| q | Tightening can be done in several stages |
| q | The angle of tightening can be measured with protractor -T20030- |
| 9 - | 45 Nm |
| 10 - | Washer |
| 11 - | Tensioner |
| 12 - | Tensioning element |
|
|
