Leon Mk2
| Subframe: Assembly overview (Altea, Altea XL, Leon) |
| 1 - | Centre hex stud |
| q | Engine support to engine |
| q | Replace |
| q | Specified torques and installation sequence → Fig.. |
| 2 - | Engine support |
| q | removing and fitting → Chapter |
| 3 - | Bolt. |
| q | Engine support to engine |
| q | Replace |
| q | Specified torques and installation sequence → Fig.. |
| 4 - | 40 Nm and then turn 90° further |
| q | Replace |
| q | Engine mounting to body |
| 5 - | Connecting link |
| 6 - | 20 Nm + 90° |
| q | Replace |
| q | Connecting plate to body |
| 7 - | 20 Nm + 90° |
| q | Replace |
| q | Connecting plate to engine mounting |
| 8 - | 60 Nm and then turn 90° further |
| q | Replace |
| q | Engine assembly to engine support |
| 9 - | Engine support. |
| q | With support arm |
| q | removing and fitting → Chapter |
| 10 - | Pendulum support |
| 11 - | 100 Nm and then turn 90° further |
| q | Replace |
| q | Pendulum support to assembly mounting |
| 12 - | 60 Nm + 90° |
| q | Replace |
| q | Pendulum support to gearbox |
| 13 - | 40 Nm + 90° |
| q | Replace |
| q | Pendulum support to gearbox |
| 14 - | 60 Nm and then turn 90° further |
| q | Replace |
| q | Gearbox mounting to gearbox support |
| 15 - | 40 Nm and then turn 90° further |
| q | Replace |
| q | Gearbox mounting to body |
| 16 - | Gearbox mounting |
| q | With support arm |
| 17 - | Final drive support |
| 18 - | Bolt. |
| q | Gearbox support on gearbox. |
| q | Tightening torque → Rep. gr.34 |
| 19 - | Bolt. |
| q | Support to gearbox. |
| q | Tightening torque → Rep. gr.34 |
| 20 - | Support |
| 21 - | Bolt. |
| q | Support element to gearbox support |
| q | Tightening torque → Rep. gr.34 |
Note
|
|
| stage: | Bolts | Tightening torque / turning further angle |
| 1. | -1 … 3- | 7 Nm |
| 2. | -1 … 3- | 40 Nm |
| 3. | -1 … 3- | turn 180° further |
