seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Components of the oil supply line and supports of the exhaust gas turbocharger to the exhaust gas turbocharger - Assembly overvi > < Checking oil pressure

Leon Mk2

Removing and installing oil pressure switchF1
Removing and installing oil pressure switch -F1-
t  Removing → Anchor
t  Fitting → Anchor
   
Removing
–  Loosen the engine cover at the locations -arrows- and remove.
  E10-10087
–  Press release tabs and disconnect crankcase breather hose -1-.
–  Leave the vacuum hoses -arrows- loose.
–  Release the hose clamp -3- and remove the air conduit from the air filter housing.
–  Unscrew bolt -2- , swivel the intake hose with intake sleeve to the back and detach it from the exhaust gas turbocharger.
  A21-10437
–  Remove bolts -2- and -3- and remove engine lifting eye -1-.
–  Disconnect electrical connector -arrow-.
–  Unscrew the oil pressure switch -F1-.
Installing
l  Tightening torques → Fig.
Installation is carried out in the reverse order; note the following:
  Note
Renew seal.
–  Install vacuum line to exhaust gas recirculation cooler.
–  Install intake connection.
  A17-10550

Components of the oil supply line and supports of the exhaust gas turbocharger to the exhaust gas turbocharger - Assembly overvi > < Checking oil pressure