seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Coolant pump: Installing and removing: > < Coolant: drain and refill

Leon Mk2

Radiator: Installing and removing:
Radiator: Installing and removing:
t  Removing → Anchor
t  Installing → Anchor.
t  Vehicles with air conditioning/heating: additional instructions and assembly information → Anchor
   
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
t  Torque wrench kit -SAT 8010-, see equivalent → Anchor
t  Measuring tool -T10007-, see equivalent → Anchor
t  Pliers -T20029- or pliers -T20174-, see equivalent → Anchor
t  Centre guide -T20070-, see equivalent → Anchor
t  Recipient tray -T20173-, see equivalent → Anchor
Removing
–  Removing front bumper trim: → Bodywork, exterior fitting work; Rep. Gr.63
  L19-10007
–  Move the lock carrier in service position: → Bodywork, exterior fitting work; Rep. Gr.50.
–  Drain coolant → Chapter
–  Pull coolant hoses off radiator.
–  Unplug the radiator fan thermal switch -F18- connector.
–  Unscrew radiator bolts and take out radiator downwards.
Vehicles with air conditioning:
–  Follow the additional instructions and assembly work → Anchor.
Installing
Installation is carried out in the reverse order of removal while noting the following:
  Note
t  Replace seals and O-rings.
t  Secure all hose connections with the correct hose clips (same as original equipment) → Spare parts catalogue.
  WARNING
When assembling the supercharger air pipes, do not use an oil-based lubricant.
–  Fit the supercharger air system hoses and observe the assembly instructions → Chapter.
–  Fill up coolant → Chapter.
Vehicles with air conditioning/heating: additional instructions and assembly information
  WARNING
The air conditioning cooling circuit must not be opened.
  Note
To avoid damage to the condenser and refrigerant pipes/sleeves, take care not to bend, twist or stretch the pipes/sleeves excessively.
–  Remove the clip/s from the cooling agent hose/s.
–  Unscrew the condenser from its attachment to the radiator and secure it to the lock carrier plate.
  E10-0082

Coolant pump: Installing and removing: > < Coolant: drain and refill