Leon Mk2
| Engine code BMT |
| 1 - | 10 Nm |
| 2 - | Oil supply pipe |
| q | With union nut, 22 Nm |
| q | From the exhaust gas turbocharger to the oil filter bracket |
| q | Check that the oil supply pipe is not obstructed before installing |
| q | Before fitting, put engine oil on the turbocharger on the connection sleeve of the oil conduit |
| 3 - | Trim cap, 30 Nm |
| q | replace |
| q | Grease the screw thread and the head support surface with paste for high temperature bolts → Parts catalogue |
| 4 - | Seal |
| q | replace |
| 5 - | Vacuum hose |
| 6 - | Seal |
| q | replace |
| q | Note fitting position: |
| 7 - | Exhaust turbocharger |
| q | Only replace completely with the exhaust manifold |
| q | removing and fitting → Chapter |
| 8 - | To the particle filter |
| 9 - | Clamp, 7 Nm |
| 10 - | Exhaust manifold |
| q | Only replace completely with the exhaust gas turbocharger |
| 11 - | 25 Nm |
| q | replace |
| 12 - | 25 Nm |
| 13 - | Seal |
| q | replace |
| 14 - | Connecting pipe |
| q | For exhaust gas recirculation |
| q | Exhaust gas recirculation radiator: Assembly overview. → Chapter |
| 15 - | 25 Nm |
| q | replace |
| 16 - | 15 Nm |
| 17 - | O-ring |
| q | replace |
| 18 - | Banjo bolt, 60 Nm |
| 19 - | Support |
| q | For the exhaust gas turbocharger |
| q | With oil backflow line |
| 20 - | Exhaust gas temperature sender 1 -G235-, 45 Nm |
| q | Only grease the thread with paste for high temperature bolts → Parts catalogue |
| 21 - | Protective plate |
| 22 - | Joint mouth |
| q | For air cleaner/turbocharger intake hose |
| q | Air filter: Assembly overview. → Chapter |
| 23 - | 9 Nm |