seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant temperature senderG62 > < Coolant temperature sender at the radiator outletG83: Removing and installing

Leon Mk2

Pump for exhaust gas recirculation radiatorV400: Removing and installing
Pump for exhaust gas recirculation radiator -V400-: Removing and installing
t  Removing → Anchor
t  Installing → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Hose clamp -3094-, see equivalent → Anchor
  W00-0079
t  Base -VAS 6340-, see equivalent → Anchor
t  Collecting tray -VAS 6208-, see equivalent → Anchor
  W00-10380
Removing
–  Disconnect the engine cover-arrow-.
  E10-10060
–  Remove the air intake hose -Arrows-.
  WARNING
Hot coolant and vapours can cause burns!
When the engine is hot the cooling system is under pressure.
To reduce the system charge pressure, cover the expansion tank plug with a rag and open carefully.
  E13-10067
–  Disconnect the coolant hoses with the hose clamps -3094-, as shown in the figure.
–  Remove coolant hoses -2- and -3-.
–  Pull out the plug -4-.
–  Unscrew the bolt -1- and remove the pump for the exhaust gas recirculation radiator -V400- with the bracket.
–  Remove the pump for the exhaust gas recirculation radiator from the bracket.
Installing
Installation is carried out in reverse order. Note the following:
Tightening torques → Chapter „Coolant lines, coolant temperature senders, coolant circulation pump: Assembly overview“
  Note
t  Hose connections and air pipes and hoses must be free from oil and grease before fitting.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Spare parts catalogue.
t  To secure the air hoses properly at their connections, spray rust remover onto the worm thread of the used hose clips before installing.
–  Fill up coolant → Chapter.
  A19-10765

Removing and installing coolant temperature senderG62 > < Coolant temperature sender at the radiator outletG83: Removing and installing