SEAT Workshop Service and Repair Manuals

Removing and installing coolant pump t  Removing → Anchor t  Installing → Anchor Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Measuring tool -T10007-, see equivalent → Anchor

t	Base -VAS 6340-, see equivalent → Anchor

t	Torque wrench (5... 50 Nm) -V.A.G 1331-, see equivalent → Anchor

t  Collecting tray -VAS 6208-, see equivalent → Anchor Removing   Note Always replace sealing joints and rings. –  Drain coolant → Chapter. –  Put the lock carrier plate into service position without mechanical components → Rep. gr.50. –  Remove the Poly V-belt → Chapter. –  Remove toothed belt → Chapter.

–  Unscrew coolant pump securing bolts -1-, and carefully remove coolant pump -2-. Installing Installation is carried out in reverse order. The following should be taken into account:   Note t  Renew O-ring. t  The brackets for the hoses and the supercharger air system tubes must be free from oil and grease for fitting. t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Spare parts catalogue. t  To ensure that the charge air hoses can be connected securely, you must spray the screws on used screw-type clips with rust remover prior to installation. –  Clean and smooth sealing surface for O-ring as required.

–  Moisten new O-ring -3- with coolant. –  Insert coolant pump -2- into cylinder block and tighten securing bolts -1-.   Note The coolant pump plug faces downwards. –  Install notched belt (adjusting valve timing) → Chapter. –  Install vibration damper → Chapter. –  Install poly V-belt → Chapter. –  Install the lock carrier with attachments → Rep. gr.50.

–  The torque reaction support must set itself on its rubber stop by means of its self weight, then tighten the nuts -arrows-. –  Install bumper cover (front) → Rep. gr.63. –  Fill up coolant → Chapter. Tightening torques

Component	Nm
Coolant pump to cylinder block	15
Stop for torque reaction support to lock carrier	28
Hose clips (9 mm wide)	3
Hose clips (13 mm wide)	5,5