SEAT Workshop Service and Repair Manuals

Right coolant pipe: Removing and installing. t  Removing → Anchor. t  Installing → Anchor. Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Special tools and workshop equipment required

t	Hose clamp -3094-, see equivalent → Anchor

t	Tray -VAS 6208-, see equivalent → Anchor

t	Base -VAS 6499-, see equivalent → Anchor

Removing .

–  Remove the engine cover upwards -arrows-.

–  Loosen bolt -1-. –  Unscrew bolt -2- and nut -3-. –  Take hose retainer -4- off fuel filter, place fuel filter -7- aside (fuel hoses -5- and -6- remain connected).

–  Fit the centre noise insulation -fasteners 1 ... 3-.

–  Remove the right wheel housing -Fixing parts 1 ... 3-.

–  Place the drip tray -VAS 6208- under the engine. –  Unplug electrical connector -3- at gearbox speed sender -G38-. –  Disconnect the coolant hoses using the hose clip -3094- and remove from the right coolant. For this purpose, loosen the clip -arrow-. –  Unscrew nut -1- and bolt -2-, and remove right coolant pipe. Installing . l  Specified torque → Chapter. Installation is carried out in the reverse order; note the following:   Note Secure all hose connections with the correct type of hose clips (same as original equipment) → Parts catalogue. –  Install the right wheel housing → Bodywork, exterior fitting work; Rep. gr.50. –  Fit the centre sound proofing → Exterior body installation work; Rep. gr.50 . –  Install fuel filter → Chapter. –  Check coolant level → Anchor.