seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Cylinder head covers: removing and installing > < Cylinder head - Components overview

Leon Mk2

Cylinder head cover: component overview
Cylinder head cover: component overview
  Caution
When installing a new partial engine, the clamping pieces of the injector must be tightened to the specified tightening torque following installation of the high pressure lines → Chapter. The clamping pieces are supplied tightened »hand tight« so that the position of the injectors can be adjusted during the installation of the high pressure lines. Non-observance of these details may lead to damage to the engine.
   
1 - 5 Nm
2 - High-pressure reservoir (rail element)
q   With injection lines.
q   Do not attempt to bend injector pipes to a different shape.
3 - 22 Nm
4 - Injector (piezo injectors)
q   Removing and installing → Chapter.
5 - 5 Nm
6 - Cover for injector
7 - Bearing bush
q   For the high-pressure reservoir (Common Rail)
q   Renew if damaged.
8 - 10 Nm
9 - Clamping piece
q   Note installation position → Fig..
10 - Cable guide
11 - Cylinder head cover
q   Removing and installing → Chapter.
12 - Gasket
q   Renew if damaged or leaking.
13 - 10 Nm
q   Observe tightening sequence → Chapter.
14 - Cap
15 - Heat shield

   
Clamping piece installation position
  N23-10231

Cylinder head covers: removing and installing > < Cylinder head - Components overview