seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Safety precautions > < Fuel system: Assembly overview

Leon Mk2

Direct diesel injection system
Direct diesel injection system
The diesel direct injection system control unit is equipped with a fault memory. Before any repair work or fitting work, consult the fault memory.
t  → Chapter „Safety precautions“.
t  → Chapter „Rules for cleanliness“.
t  → Chapter „Fitting locations overview“.
t  → Chapter „System layout“.
t  → Chapter „Fuel system: component overview“.
t  → Chapter „Air filter: component overview“.
t  → Chapter „Engine cover: Removing and installing.“.
t  → Chapter „Removing and installing air filter element“.
t  → Chapter „Removing and installing air filter housing“.
t  → Chapter „Removing and installing air mass meter -G70-“.
t  → Chapter „Intake manifold flap motor -V157-: Removing and installing.“.
t  → Chapter „Intake manifold and accessory parts: component overview“.
t  → Chapter „Removing and installing intake manifold“.
t  → Chapter „Removing and installing rail element (high-pressure accumulator)“.
t  → Chapter „Checking injectors (piezo injectors) “.
t  → Chapter „Adaptation of the injector delivery calibration values and the injector voltage calibration values: carry out“.
t  → Chapter „Reverse flow quantity of the injectors (piezo injectors) check when the engine is running“.
t  → Chapter „Reverse flow quantity of the injectors (piezo injectors) check at starter cranking speed“.
t  → Chapter „Pressure retention valve in fuel return line: check“.
t  → Chapter „Fuel low pressure line: check“.
t  → Chapter „Fuel pumps: Checking delivery rate“.
t  → Chapter „Injectors (piezo injectors) Removing and installing.“.
t  → Chapter „Installing high-pressure lines“.
t  → Chapter „Removing and installing high-pressure pump“.
t  → Chapter „Performing first fuel filling after installing high-pressure pump“.
t  → Chapter „Sealing of the fuel system: check“.
t  → Chapter „Checking fuel pressure regulating valve -N276-“.
t  → Chapter „Removing and installing fuel pressure regulating valve -N276-“.
t  → Chapter „Removing and installing fuel pressure sender -G247-“.
t  → Chapter „Lambda probe and exhaust temperature sender: component overview“.
t  → Chapter „Lambda probe -G39- withheating for the lambda probe -Z19- Removing and installing.“.
t  → Chapter „Exhaust gas pressure sensor 1 -G450-: Removing and installing“.
   

Safety precautions > < Fuel system: Assembly overview