Leon Mk2
| Part I: |
| 1 - | 15 Nm |
| 2 - | Oil dipstick |
| q | The oil level must not be above the MAX mark! |
| 3 - | Filling funnel |
| 4 - | Guide pipe |
| 5 - | Intermediate plate |
| 6 - | Oil pump with rotational balancing unit |
| q | With pressure relief valve 12 bar |
| q | removing and fitting → Chapter |
| 7 - | 15 Nm + 90° (1/4 turn) |
| q | Replace |
| q | Take into account the different lengths of the bolts → Fig. |
| 8 - | 15 Nm |
| 9 - | Oil pan |
| q | Clean sealing surface before installing |
| q | removing and fitting → Chapter |
| 10 - | 15 Nm |
| 11 - | Oil seal |
| q | Surrounds the vent screw → Item |
| 12 - | Oil drain plug, 30 Nm |
| q | With safety washer |
| q | Replace |
| 13 - | Torque reaction support |
| 14 - | 23 Nm |
| 15 - | Pinions |
| q | Note fitting position: |
| q | Sprocket can only be fitted on oil pump shaft in one position. |
| q | Crankshaft chain sprocket: replacing → Chapter |
| 16 - | 20 Nm + 90° (1/4 turn) |
| q | Replace |
| 17 - | Chain guard |
| 18 - | Chain for oil pump |
| 19 - | Sealing flange |
| q | Must sit on dowel sleeves |
| q | removing and fitting → Chapter |
| q | For removing and installing, detach the oil sump → Chapter |
| q | Renewing crankshaft oil seal on pulley end → Chapter |
