seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil pressure and oil pressure switch: checking > < Removal:

Leon Mk2

Fitting .
Fitting .
Premise
   
l  One of the cam rods -arrow-is in the crankshaft in the upper section.
  N17-0081
–  Place the Allen bolt of the Inlay tool for seals -3083- using the assembly tool -T10022- onto the crankshaft and fasten by hand.
–  Place the new gasket onto the dowel sleeves -A-.
  N17-0075
–  Line up arrow -A- of the interior rotor of the oil pump with the assembly position mark -B- on the cover of the oil pump housing.
–  Oil the crankshaft cam rods.
–  Lightly oil the sealing lip of the oil pump seal.
–  Carefully guide the oil pump over the crankshaft cam rods.
–  If given, line up the interior rotor, slightly offsetting with respect to the drive rod in the crankshaft.
–  Next, carefully fit the oil pump on the guide pins.
–  Use new bolts to fasten the oil pump. Tightening torque: 12 Nm
–  Remove the assembly device -T10022-.
–  Fit extraction hose → Item.
–  Remove sump → Chapter.
–  Fit the principal notched belt tension roller → Chapter
  N17-0074

Oil pressure and oil pressure switch: checking > < Removal: