Leon Mk2
Part I |
1 - | Tension pulley |
q | Only for vehicles fitted with air conditioning |
2 - | 20 Nm |
3 - | Tensioning rod |
q | Lubricate using -G 000 100- |
4 - | Dust protection cover |
5 - | Expansive clip |
6 - | Upper protection cover of the notched belt |
7 - | Notched belt |
q | Before removing this, mark the rotation direction |
q | Check for wear |
q | Do not bend |
q | Removing and fitting, tightening → Chapter |
8 - | 45 Nm |
q | 20 Nm with semi automatic tensioning pulley |
9 - | Off centre |
q | For semi automatic tensioning pulley |
10 - | Tension pulley |
q | Verification → Chapter |
11 - | 45 Nm |
12 - | Cogwheel for timing belt |
q | Remove the camshaft from the cone by tapping once with a hammer and punch through the opening in the protective cover for the notched belt |
13 - | 25 Nm |
14 - | Idler roller |
q | For other engine identification letters |
15 - | 10 Nm |
16 - | Rear protection cover of the notched belt |
17 - | Injection pump cogwheel |
q | Single piece |
18 - | Injection pump cogwheel |
q | Two piece |
19 - | Injection pump |
q | Removing and fitting: → Rep. Gr.23 |
20 - | Support |
21 - | Console |
22 - | Intermediate shaft pulley |
23 - | Notched belt wheel/crankshaft |
24 - | 90 Nm + 1/4 turn (90°) |
q | Replacement |
q | Stop the spin by griping and loosening using the -T20018A- tool |
q | Retightening cannot be carried out in stages |
25 - | 45 Nm |
26 - | Lower protection cover of the notched belt |
27 - | Liquid coolant pump pulley |
q | Poly-V belt version |
28 - | Poly-V belt |
q | Before removing this, mark the rotation direction |
q | Removing and fitting → Chapter |
29 - | Belt pulley/vibration damper |
q | Attachment is only possible in one position, the openings are distributed asymmetrically |
30 - | Trapezoidal drive belt |
q | Adjustment of the trapezoidal drive belt tension → Rep. Gr.48 |
31 - | Liquid coolant pump pulley |
q | Version for trapezoidal drive belt |
32 - | Crankshaft pulley |