Leon Mk2
| Part II |
| 1 - | Cylinder head cover |
| 2 - | Cover |
| q | Replace the gasket if it is deteriorated |
| 3 - | Upper sealing washer |
| 4 - | Washer |
| 5 - | 10 Nm |
| 6 - | Cap |
| 7 - | To the flexible suction tube |
| 8 - | Clip |
| 9 - | Pressure regulator valve |
| q | Cylinder block breather |
| 10 - | Gasket |
| q | Replace if damaged |
| 11 - | Cylinder head cover gasket |
| q | Replace if damaged |
| 12 - | Cylinder block breather |
| 13 - | Cylinder head bolt |
| q | Replacement |
| q | Follow the correct order for loosening, tightening and the tightening torque → Chapter |
| 14 - | Attachment clip |
| 15 - | O-ring |
| q | Replacement |
| 16 - | Lower sealing cone |
| 17 - | Injection tubes |
| q | Tighten to 25 Nm |
| q | Loosen and tighten using the -U-40072- tool |
| q | Always remove the complete set of tubes |
| q | Do not modify the curvature |
| 18 - | Cylinder head |
| q | Disassembling and assembling → Chapter |
| q | If replaced, renew all the coolant |
| 19 - | Cylinder head gasket |
| q | Replacement |
| q | Observe the labelling → Chapter |
| q | If replaced, renew all the coolant |
| 20 - | 20 Nm |
| 21 - | Ring |
