–
| Use the pusher -T20081/1- and press the guide sleeve-seal unit all the way on. To do so, use the pinion mounting bolt. |
–
| Remove guide sleeve -T20081/5-. |
–
| Install the camshaft pinions. |
Note! Check the position of the pinions with respect to the camshafts keys. |
–
| Immobilise the respective pinion with locking tool -T10016- and tighten the bolts to a torque of 20 Nm. Continue tightening 1/4 turn (90°). |
–
| Installation of the toothed belt → Chapter. |
Continue the installation in the reverse order of removal. |
|
|
|