| –
| Use plunger -T20081B/1- and press the guide sleeve - seal unit on until the seal is properly seated. To do so use the old fixing bolt for the vibration dampener. |
| –
| Remove guide sleeve -T20081B/2-. |
| –
| Fit the toothed belt pinion. To do so immobilise it with countersupport -T20018A- and tighten the new fixing bolt to a torque of: 90 Nm + 1/4 turn (90o) |
Note! | The retightening angle may be measured with protractor -T20030- |
| Fitting the toothed belt and setting distribution timing → Chapter. |
|
|
|
