Leon Mk2
| Oil filter bracket and engine oil cooler - exploded view |
| 1 - | Seal |
| q | Replace |
| 2 - | 25 Nm + 90° (1/4 turn) further |
| q | 4x |
| q | Replace |
| q | Firstly position the upper left bolts and lower right bolts then tighten in stages diagonally |
| 3 - | Oil filter bracket |
| 4 - | O ring |
| q | Replace |
| 5 - | Joint mouth |
| q | Oil supply pipe to the turbocharger |
| 6 - | Oil supply pipe, -22 Nm |
| q | To turbocharger |
| q | removing and fitting → Chapter |
| 7 - | Oil pressure switch -F1- -20 Nm |
| q | 0.7 bar switch: Brown colour |
| q | In case of leakage, cut out and replace sealing ring |
| q | Checking → Chapter |
| 8 - | Sealing plug -25 Nm |
| q | Loosen and tighten using the wrench -T20160- |
| 9 - | O ring |
| q | Replace |
| 10 - | Oil filter element |
| q | Note the fitting position: "Top" marked |
| 11 - | Seal |
| q | Replace |
| q | Fit into lugs on oil filter bracket. |
| 12 - | Oil cooler |
| q | Ensure clearance from surrounding components |
| q | See note → Chapter |
| 13 - | Seal |
| q | Replace |
| 14 - | Screw plug, 25 Nm |
