Leon Mk2
| Ignition system - exploded view |
| 1 - | Electric connector |
| q | 4-pin, black |
| q | Remove with extractor -T10118- |
| 2 - | Ignition coils |
| q | Ignition coil 1 with output stage -N70- |
| q | Ignition coil 2 with output stage -N127- |
| q | Ignition coil 3 with output stage -N291- |
| q | Ignition coil 4 with output stage -N292- |
| q | removing and fitting → Chapter |
| 3 - | Electric connector |
| q | Black, 2-pin |
| q | For knock sensor 1 -G61- |
| q | Connector contacts are gold-plated |
| 4 - | Knock sensor 1 -G61- |
| q | removing and fitting → Chapter |
| q | Connector contacts are gold-plated |
| 5 - | Bolt |
| q | Tightening torque: 20 Nm |
| q | Tightening torque influences functions of knock sensor |
| 6 - | Electric connector |
| q | 3-pin, black |
| q | for Hall sender -G40- |
| 7 - | Hall sender -G40- |
| q | removing and fitting → Chapter |
| 8 - | O ring |
| q | Replace if damaged |
| 9 - | Bolt |
| q | Tightening torque: 10 Nm |
| 10 - | Spark plug, |
| q | Tightening torque: 30 Nm |
| q | Remove and install with the spark plug spanner -3122 B- |
| q | Type and spark gap → Chapter |
| 11 - | Cable duct |
| q | Tighten the camshaft housing to a torque of 5 Nm |
| 12 - | Earth cable |
| q | Tighten or loosen only when the ignition is off |
| 13 - | Bolt |
| q | Tightening torque: 10 Nm |
| q | Tighten or loosen only when the ignition is off |
