seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing knock sensor 1G61 > < Ignition system - exploded view

Leon Mk2

Removing and installing ignition coils with output stages
Removing and installing ignition coils with output stages
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Extractor -T10094 A-, see equivalent → Anchor
  W00-10526
t  Extractor -T10118-, see equivalent → Anchor
Ignition coil with output stage: Removing → Anchor
Ignition coil with output stage: Fitting → Anchor
  Note
The housing for the ignition coils and final power stages has been modified. As a result, the ignition coils can only be removed and mounted using the extractor -T10094 A-. The former extractor -T10094- may still be used if it is modified as follows.
  W00-1148
–  Reduce the marked zone -2- using suitable workshop methods to reach a new nominal measurement -B- of 18 mm.
–  Add the letter A to the tool description -1-.
Removing
  N28-10068
–  Fit the extractor -T10094 A-on the ignition coils with output stage -arrow- as in the illustration.
–  Lightly extract the ignition coils with output stage.
–  Position the extractor -T10118- as shown.
–  Carefully open the connector lock and remove the connector.
Installing
–  Fit the extractor -T10094 A- on the ignition coils with output stage.
–  Push the connector over the ignition coil with output stage until it snaps into place.
  N28-10066
–  Insert the ignition coil with output stage in the cylinder head in the -direction of the arrow-.
  N28-10067

Removing and installing knock sensor 1G61 > < Ignition system - exploded view