| –
| Unplug the electrical connector -3- at charge air pressure sender -G31- / intake air temperature sender 2 -G299-. |
| –
| Release the retainer -arrow- and first remove the pressure pipe from the throttle valve module -J338- and then from the exhaust gas turbocharger. |
| –
| Move hoses on air pipe clear. |
| Installation is carried out in reverse order. The following should be taken into account: |
| –
| Replace the O-ring on the side of the throttle valve module -J338-. |
| –
| Plug in the electrical connector on the charge air pressure sender -G31- / intake air temperature sender 2 -G299-. |
| –
| Tighten the fastening screw of the tab to 7 Nm. |
|
|
|
