Note | t
| When installing an exchange cylinder head, all the contact surfaces between the support elements, roller rocker fingers and cams must be oiled before installing the camshaft housing. |
| t
| The plastic protectors fitted to protect the open valves should not be removed until the cylinder head is ready to be fitted. |
| t
| If the cylinder head is replaced, all the coolant in the system must also be changed. |
| t
| Oil the support and slide surfaces before carrying out assembly work. |
| t
| Remove and install intake manifold → Chapter. |
| Check that the cylinder head is not deformed → Fig. |
| To remove, fit and tense timing belt → Chapter |
| Check the semi-automatic tension roller of the notched belt → Chapter |
| Removing and fitting the camshaft housing → Chapter |
| Removing and fitting the cylinder head → Chapter |
|
|
|
