seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Crankshaft dimensions > < E - Check the fitting position of the sender wheel on the crankshaft.
F - Correct the installation location of the sender wheel
F - Correct the installation location of the sender wheel
   
–  Move the installation bell -A- by hand towards the sealing flange -B-.
–  Screw in the 2 bolts M6 x 35 -C- on the engine block to guide the sealing flange -B-.
–  Tighten by hand the hexagonal bolt -D- on the threaded spindle until it comes into contact with the installation bell -A-.
  N13-0420
–  Tighten the hexagon nut of the assembly tool using the torque wrench -VAG 1331- and tighten using the insert 24mm terminal -VAG 1332/11-. Tightening torques: 40 Nm.
–  Check the fitting position of the sender wheel on the crankshaft once more → Chapter.
If the size -a- is still too small:
–  Tighten the hexagonal bolt of the fitting device to a torque of 45 Nm.
–  Check the fitting position of the sender wheel on the crankshaft once more → Chapter.
  N13-0617

Crankshaft dimensions > < E - Check the fitting position of the sender wheel on the crankshaft.