seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Crankshaft > < Removing and installing flywheel

Leon Mk2

Drive plate: removing and installing
Drive plate: removing and installing
Removing → Anchor.
Installing → Anchor.
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Retention tool -VW 558-, see equivalent → Anchor
t  Gauge
t  Hex bolt M8 × 45 and 2 hex nuts M10
removing
–  Fastenthe holder -VW 558- with the hexagonal screw M8 x 45 to the driving disk. Attach two nuts M10 between holders and driving disk.
  W00-0252
Installation position of the holding device -A- to loosen, -B- for tightening
Fitting
  N13-10121
–  Fit the drive plate using the washer with recesses -1-.
–  Insert new bolts -3- and tighten to a torque of 30 Nm.
–  Check dimension -a- at 3 points and calculate the average.
  N13-0640
Specification: 19.5 - 21.1 mm
  Note
The measurement is made through the hole of the drive plate to the bored surface of the cylinder block.
If the specifications are not met:
  N13-0641
–  Remove the drive plate again and use the compensation washer -2-. Tighten the bolts again -3- to a torque of 30 Nm.
–  Tighten the bolts to a torque of 60 Nm + 1/4 turn (90°) (the retightening can be done in several stages).
  N13-0640

Crankshaft > < Removing and installing flywheel