SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Securing engine to assembly stand >
< Removing engine
Leon Mk2
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Engine assy,cylinder block,crankcase / Removing and installing engine
Detaching engine from gearbox
Detaching engine from gearbox
Detaching engine from gearbox
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
counterhold -T20186-, see equivalent
→ Anchor
t
Workshop hoist
Conditions
l
Engine / gearbox assembly is removed and attached to the engine bracket -T10416-.
Procedure
–
Unscrew bolt
-1-
with gearbox fitted.
–
Pull the cover plate
-2-
off upwards.
Note
This is shown in the figure with the gearbox removed.
–
Unscrew the bolts
-1 … 8-
on the flange between the engine and the gearbox.
–
Take out starter motor.
Note
The gearbox is shown in illustration with engine removed.
–
Place the support tool -T20186- on the gearbox, as shown in the illustration.
–
Carefully separate the gearbox from the engine, using the workshop crane.
Power unit
4 cylinder Injection engine (1.2 l direct injection engine, turbocharger)
Engine assy,cylinder block,crankcase / Removing and installing engine
Detaching engine from gearbox
Securing engine to assembly stand >
< Removing engine