seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Cooling system components, bodywork side - Assembly overview (Altea, Altea XL, Leon) > < Radiator to charge air cooler: Installing and removing (Ibiza)

Leon Mk2

Components of the cooling system: Removing and installing
Components of the cooling system: Removing and installing
  Caution
t  When doing any repair work, especially in the engine compartment, pay attention to the following due to the cramped conditions:
t  All the various lines (e.g. fuel, coolant, refrigerant, vacuum and electrical wiring) must be installed so that their original positions are reproduced.
t  In order to avoid damage to the lines, ensure sufficient clearance for all moving or hot components.
  Note
t  When the engine is hot the cooling system is under pressure. If necessary, relieve pressure before commencing repair work.
t  Hoses are secured with spring-type clips. In case of repair, only use spring-type clips.
t  Hose clip pliers -VAS 6340- are recommended for fitting spring-type hose clips.
t  Coolant hoses should be free from tension when installing, so that they do not come into contact with other components (observe markings on coolant connection and hose).
Perform cooling system leakage check with cooling system tester -VAG 1274B- and the adaptor -VAG 1274/8- and the adaptor -VAG 1274/9-.
→ Chapter „Cooling system components, bodywork side - Assembly overview (Altea, Altea XL, Leon) “
→ Chapter „Cooling system components, bodywork side - Assembly overview (Ibiza)“
→ Chapter „Cooling system components, engine side - Assembly overview“
→ Chapter „Diagram of coolant hose connections“
→ Chapter „Draining off and filling coolant“
→ Chapter „Coolant pump: Exploded view of components“
→ Chapter „Poly V-belt pulley for coolant pump: Removing and installing“
→ Chapter „Coolant pump: Removing and installing“
→ Chapter „Removing and installing coolant circulation pump -V50-“
→ Chapter „Removing and installing coolant temperature sender -G62-“
→ Chapter „Coolant temperature sender at the radiator outlet -G83-: Removing and installing“
→ Chapter „Removing and installing thermostat housing and coolant pipe (rear)“
→ Chapter „Right coolant pipe: Removing and installing“
→ Chapter „Radiator fan -V7-: removal and installation (Altea, Altea XL, Leon) “
→ Chapter „Check the cooling system for leaks“
→ Chapter „Radiator: removal and installation (Altea, Altea XL, Leon) “
   

Cooling system components, bodywork side - Assembly overview (Altea, Altea XL, Leon) > < Radiator to charge air cooler: Installing and removing (Ibiza)