seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Drive plate: Removing and installing > < Sheet plate seal: Removing and installing

Leon Mk2

Flywheel: Removing and installing
Flywheel: Removing and installing
t  Removing → Anchor
t  Fitting → Anchor.
Special tools and workshop equipment required
   
t  Counterhold -T20176-
  W00-2458
t  Adaptor -U-10050-10- with Adaptor -U-10050/F-
Requirement
l  Gearbox is separated from engine
  W00-2960
Removing
–  Fix counterhold -T20176- in the adapter -T20172A- or in the cylinder block orifice and immobilise the flywheel.
–  Remove the pressure disc → 5 speed manual gearbox 0AF; Rep. gr.30
–  Mark the position of the flywheel on the crankshaft with a permanent marker.
–  Extract the bolts fixing the flywheel and remove it.
Installing
Installation is carried out in the reverse order of removal while noting the following:
–  Position the flywheel on the crankshaft in the previously marked position.
–  Replace bolts and tighten to prescribed torque → Item.
–  Remove the pressure disc → 5 speed manual gearbox 0AF; Rep. gr.30
  E30-10017

Drive plate: Removing and installing > < Sheet plate seal: Removing and installing