| –
| Disconnect connection -1- from air mass sensor -G70-. |
| –
| Unscrew both bolts from air mass meter -G70- and carefully pull air mass meter -G70- out of guide on air cleaner housing. |
| To ensure the proper function of the air mass meter -G70- it is important to observe the following notes and instructions. |
Note | t
| If the air filter element is very dirty or wet, dirt or water could reach the air mass meter -G70- and affect the air mass value. This would lead to loss of power, since a smaller injection quantity is calculated. |
| t
| Always use genuine part for air filter element. |
| t
| Use a silicone-free lubricant when installing the intake hose. |
| –
| Check for salt residue, dirt and leaves in air mass meter and air intake hose (engine intake side). |
| –
| Check for dirt in air duct leading to air filter element. If contamination is found, remove salt residues, dirt and leaves from top and bottom part of air filter housing by rinsing out or using a vacuum cleaner if necessary. Air filter element: removing and fitting → Chapter. |
| Further assembly in reverse order of removal. |
|
|
|
