seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Radiator: removal and installation > < Evacuation
Filling
Filling
  Note!
t  Only use antifreeze additive G 12 according to specification TL -VW 774 F-. Identification: purple colour.
t  The purple G 12 (in accordance with standard TL -VW 774 F-) may be mixed with the previous used red G 12 antifreeze additive.
t  On no account must G 12 be mixed with other anti-freeze additives.
t  If the fluid in expansion tank is brown, G 12 has been mixed with other anti-freeze additives. In this case the coolant must be changed.
t  G 12 and anti-freeze additives marked ”In accordance with TL -VW 774- D” prevent frost and corrosion damage, scaling and also raise boiling point of coolant. For this reason the system must be filled all year round with anti-freeze and corrosion protection additives.
t  Because of its high boiling point, the coolant improves engine reliability under heavy workloads, particularly in countries with tropical climates.
t  The anti-freeze protection should be guaranteed to approx. -25 °C (in countries with arctic weather up to approx. -35 °C).
t  Coolant concentration must not be reduced by adding water, even in warmer seasons or in warmer countries. The percentage of anti-freeze additive should be at least 40%.
t  If for climatic reasons a greater frost protection is required, the amount of G 12 can be increased, but only up to 60 % (frost protection to about -40 °C) With a greater concentration engine cooling and anti-freeze properties are diminished.
t  If radiator, heat exchanger, cylinder head or cylinder head gasket has been replaced, do not reuse old coolant.
Recommended mixture ratios:
   
Anti-freeze protection untilAnti-freeze proportionG 12 → NoteWater → Note
-25 °C
-35 °C
40 %
50 %
2,0 litre
2,5 litre
3,0 litre
2,5 litre

1)  Coolant quantity: 5.0 litres; may vary depending on the vehicle equipment
   
–  Screw bleeding screw -arrow- into the radiator.
  A10-0118
–  Connect the coolant flexible tubing onto the connection hose for the oil radiator and fit the clip -arrow- using the pliers -T20029-.
  A10-0162
–  Fill with coolant up to max. mark on expansion tank.
–  Close expansion tank cap.
–  Start engine and run engine at approx. 2,000 rpm for 3 minutes.
–  Run engine until radiator fan cuts in.
–  Check coolant level and top up if necessary. When the engine is at normal operating temperature, the coolant level must be on the max. mark, and when the engine is cold, between the min. and max. marks.
–  Fit the central sound proofing (depending on the version): → Exterior; Rep. Gr.50.
  E00-0154

Radiator: removal and installation > < Evacuation