seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine code BLY and BVZ. Lambda probeG39 and lambda probe after catalytic converterG130 removing and installing > < Engine code BLR and BVY. Removing and installing Lambda probe after catalytic converterG130 and Lambda probe 2 after catalytic c

Leon Mk2

Engine code BLR and BVY. Removing and installing Lambda probe 3 after catalytic converterG287
Engine code BLR and BVY. Removing and installing Lambda probe 3 after catalytic converter -G287-
t  Removing → Anchor
t  Installing → Anchor
Special tools and workshop equipment required
   
t  Special wrench -U-40080-
  W00-2236
Removing
–  Remove right vehicle floor cover -arrows-.
  A10-1663
–  Remove the connector-2- for Lambda probe III after catalytic converter -G287- and Heater for lambda probe 3, after catalytic converter -Z64-.
  E26-10008
–  Unbolt Lambda probe III after catalytic converter -G287- and Heater for lambda probe 3, after catalytic converter -Z64-, -1- using the Wrench -U-40080-.
Installing
When fitting, note the following:
  Note
t  The screw thread on the new lambda probe is coated with a special paste; the paste must not get into the slots on the probe body
t  If a lambda probe is reused, apply paste to the bolts when warm; the paste must not get into the slots on the probe body. Locking fluid for hot working bolts → ETKA (Electronic parts catalogue)
t  When assembling, the lambda probe cable must be fixed in its original position to avoid contact with the exhaust pipe.
t  Tightening torque: 55 Nm.
  A24-0784

Engine code BLY and BVZ. Lambda probeG39 and lambda probe after catalytic converterG130 removing and installing > < Engine code BLR and BVY. Removing and installing Lambda probe after catalytic converterG130 and Lambda probe 2 after catalytic c