seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust system > < Engine code BLR and BVY. Removing and installing Lambda probe 3 after catalytic converterG287

Leon Mk2

Engine code BLY and BVZ. Lambda probeG39 and lambda probe after catalytic converterG130 removing and installing
Engine code BLY and BVZ. Lambda probe -G39- and lambda probe after catalytic converter -G130- removing and installing
t  Removing → Anchor
t  Installing → Anchor
Special tools and workshop equipment required
   
t  Special wrench -U-40080-
  W00-2236
Removing
–  Remove right vehicle floor cover -arrows-.
–  Remove the connector from the corresponding lambda probe.
  A10-1663
–  Unbolt the Lambda probe -G39--1- or the lambda probe after the catalytic converter -G130--2-using the Wrench -U-40080-.
Installing
When fitting, note the following:
  Note
t  The screw thread on the new lambda probe is coated with a special paste; the paste must not get into the slots on the probe body
t  If a lambda probe is reused, apply paste to the bolts when warm; the paste must not get into the slots on the probe body. Locking fluid for hot working bolts → ETKA (Electronic parts catalogue)
t  When assembling, the lambda probe cable must be fixed in its original position to avoid contact with the exhaust pipe.
t  Tightening torque: 55 Nm.
  A24-0784

Exhaust system > < Engine code BLR and BVY. Removing and installing Lambda probe 3 after catalytic converterG287