Leon Mk2
|
1 - | Intake manifold |
q | Tighten securing bolts to 22 Nm |
q | Removing and installing → Chapter |
2 - | O ring |
q | Replace |
3 - | Intake sleeve |
q | With mechanical exhaust gas recirculation valve |
4 - | 10 Nm |
5 - | Intake manifold flap motor -V157- |
q | Removing and installing → Chapter |
6 - | 10 Nm |
7 - | Connecting pipe |
q | To exhaust gas recirculation cooler. |
8 - | 22 Nm |
9 - | Seal |
q | Replace |
|
1 - | Intake manifold |
q | Tighten securing bolts to 22 Nm |
q | Removing and installing → Chapter |
2 - | O ring |
q | Replace |
3 - | Intake sleeve |
q | With exhaust gas recirculation valve and intake flap |
4 - | 10 Nm |
5 - | Seal |
q | Replace |
6 - | Connecting pipe |
q | To the exhaust inlet manifold |
7 - | 10 Nm |
8 - | Spring retainer |
9 - | Depression actuator |
10 - | To the solenoid valve block |
11 - | 22 Nm |
|
1 - | 10 Nm |
2 - | exhaust gas recirculation radiator |
3 - | O ring |
q | Replace |
4 - | 10 Nm |
5 - | Exhaust gas recirculation valve -N18- with potentiometer for exhaust gas recirculation -G212- |
q | Removing and installing → Chapter |
6 - | 22 Nm |
7 - | 10 Nm |
8 - | Intake manifold |
q | Removing and installing → Chapter |
9 - | O ring |
q | Replace |
10 - | Seal |
q | Replace |
11 - | Intermediate hose |
q | if necessary, remove the existing carbon oil residues |
12 - | O ring |
q | Replace |
13 - | Intake manifold flap motor -V157- |
q | The intake manifold plate closes about 3 seconds when the engine is stopped and then reopens. In this way a stopping jerk is avoided |
14 - | 10 Nm |
15 - | Seal |
q | Replace |
16 - | 22 Nm |