Leon Mk2
Fuel tank with accessory parts - Component overview (four wheel drive) |
1 - | 26 Nm |
2 - | Heat shield plate for fuel tank |
q | With panel support |
3 - | Fuel supply line |
q | Black |
q | To fuel filter |
q | Do not kink |
q | Install on fuel tank |
4 - | Fuel return line |
q | Blue colour |
q | From fuel cooler |
q | Do not kink |
q | Install on fuel tank |
5 - | Electrical connector |
q | For the fuel pre-supply pump -G6- and the fuel level gauge sender -G- |
6 - | Seal |
q | Replace if damaged |
7 - | Sealing plug |
q | Use a safety pin to fasten the cover assembly to the tank. |
8 - | Earth connection |
q | To deflect the electrostatic charges |
q | Installation position → Anchor |
q | Ensure that connector is seated properly and screw the lines together with the collared securing bolt for fuel filler neck -Item 9-. |
q | After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part on the body: Specification approximately: 0 ohms |
9 - | Collar screw 11 Nm |
q | Secures fuel filler neck and earth connection -item 8- |
10 - | Electrical connector |
q | For fuel gauge sender 2 -G169- |
11 - | Fuel tank |
q | Removing and installing → Chapter |
12 - | tension belt |
q | Fitting position: the fixing point (holes) points in direction of travel |
13 - | 26 Nm |
|