seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Hydraulic bucket tappet: check > < Camshaft: removing and fitting

Leon Mk2

Roller rocker arms: removing and fitting
Roller rocker arms: removing and fitting
t  Removing → Anchor
t  Fitting → Anchor
t  Specified torques → Anchor.
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Extraction tool -T10133-, see equivalent → Anchor
  W00-1258
Removing
–  Remove battery → Electrical system; Rep. Gr.27
–  Remove the battery tray -arrows-.
–  Remove camshafts, → Chapter.
  A10-1572
–  Mark the correspondence of the roller rocker arms and their shafts for subsequent fitting.
–  Extract the roller rocker arm shaft -1- from the cylinder head on the supply side using the extractor -T10133/3-.
–  Remover the roller rocker arms.
–  Unscrew bolts -4- and -5-.
–  Extract the roller rocker arm shaft -3- from the cylinder head on the exhaust side.
Fitting
Installation is carried out in the reverse order of removing, when doing this note the following.
  Note
Replace the O-ring -2-.
–  Oil the roller rocker arm contact points before fitting.
–  Install the camshaft → Chapter
–  Install battery → Electrical system; Rep. Gr.27.
Specified torques .
  A15-0952
ComponentNm
Rocker arm shaft to cylinder head10
Roller rocker arm shaft seal bolt to the cylinder head10 → Note

1)  Fit with locking fluid; locking fluid → Parts catalogue
   

Hydraulic bucket tappet: check > < Camshaft: removing and fitting