| –
| Unscrew the two holding screws -arrows- of the air mass gauge -G70-. |
| –
| Carefully extract the air mass gauge -G70- from the air filter housing guide. |
| So that the air mass gauge function correctly, it is necessary to respect the indications and steps described next. |
Note | t
| If the air filter element is very dirty or wet, the air mass gauge could get dirty with dust particles or get wet and therefore the readings will be incorrect. The consequence is a loss of power as the calculated quantity to be injected will be less. |
| t
| Genuine cartridges must always be used for the air filter. |
| t
| Fit the charge air system lines, follow the instructions during this → Chapter. |
| –
| Check that there are no salt residues, dirt or leaves in the air mass gauge, or in the air duct hose (clean air side). |
| –
| Check that there is no dirt between the air duct and the air filter element. Check that there are no salt residues, dirt or leaves in the air filter housing (top and bottom); clean or vacuum if necessary. |
| Further installation is carried out in the reverse order. |
|
|
|
