seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil pressure and oil pressure switch checking > < Oil pump removal and installation|Installation

Leon Mk2

Work sequence
Work sequence
–  Place new gasket on the guide pins on engine block.
–  Apply oil to the four polygon cams on crankshaft.
   
–  Position one of the oil pump inner rotor markings arrow -A- on installation position mark arrow -B- on oil pump housing cover.
–  Lightly oil sealing lip of oil pump oil seal.
  N17-0074
–  Introduce guide sleeve -T20081B/2- from puller -T20081B- on the premounted oil seal on the oil pump.
–  Guide oil pump carefully onto crankshaft polygon cams.
–  Align inner rotor to crankshaft polygon cams by turning slightly if necessary.
–  Then slide oil pump carefully onto guide pins.
–  Secure oil pump with new bolts. Tightening torque: 12 Nm
–  Separate guide sleeve -T20081B/2-
–  Install suction pipe → Item.
–  Install sump → Chapter.
Installing toothed belt and adjusting valve timing → Chapter.
–  Install ribbed belt → Chapter.
  E17-0016

Oil pressure and oil pressure switch checking > < Oil pump removal and installation|Installation