seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Brake pads: removing and fitting - front brake FS III|Fitting > < Brake pads: removing and fitting - front brake FS III

Leon Mk2

Removal:
Removal:
–  Remove wheel.
  Note
t  Mark the brake pads that are going to be re-used before removing them. It is necessary to fit them in the same position. If not, the braking effect will not be uniform.
t  Do not unscrew hose when replacing brake pads.
   
–  Remove the protective covers -arrows-.
  A46-0086
–  In vehicles with brake pad corrosion indicator, the connector has to be disconnected -1-.
  N46-0263
–  Unscrew both guide pins -arrows- from the brake calliper and remove them.
–  Remove the brake calliper and hook with a piece of wire so that the weight of the calliper does not pull on or damage the brake hose.
–  Remove the brake pads from the brake calliper housing.
  Note
Only alcohol may be used to clean the brake calliper housing.
  A46-0087

Brake pads: removing and fitting - front brake FS III|Fitting > < Brake pads: removing and fitting - front brake FS III