Leon Mk2
| FS III front wheel brakes - general assembly overview |
| 1 - | Brake disc |
| q | Thickness: 22 mm |
| q | Wear limit: 19 mm |
| q | Always replace by axles |
| q | To remove it, beforehand unscrew the brake callipers |
| q | Do not use force to separate the brake from the wheel stock, use deoxidant if necessary, as the brake disc could be damaged. |
| 2 - | Cross-head bolt |
| q | 4 Nm |
| 3 - | Brake pads |
| q | Thickness: 14 mm |
| q | Wear limit: 7 mm with back plate |
| q | Check the thickness → Booklet |
| q | Do not unscrew hose when replacing brake pads |
| q | removing and fitting → Chapter. |
| q | Always replace all the pads on the same axle |
| 4 - | Brake calliper |
| q | Do not unscrew hose when replacing brake pads |
| q | removing and fitting → Chapter. |
| q | Remove the brake pads → Chapter. |
| 5 - | Guide pin |
| q | 28 Nm |
| 6 - | Rubber cap |
| q | Remove |
| 7 - | Security spring |
| 8 - | Brake hose with hose connection and hollow bolt |
| q | Bolt tightening torque: 35 Nm |
| q | Do not dismantle, replace complete |
| q | Do not unscrew to change the brake pads |
| 9 - | Wheel hub with wheel bearing |
| q | For vehicles with ABS, a sensor ring has been fitted in the wheel bearing seal |
| q | Replace after each removal, as it is destroyed on removal |
| q | Removing and fitting → Running gear, axles, steering; Rep. Gr.40 |
| q | Allocation → Spare parts catalogue |
| 10 - | Hexagonal nut |
| q | 10 Nm |
| 11 - | Cover plate |
| 12 - | Wheel bearing housing |
| 13 - | ABS rev. sensor |
| q | Before fitting the sensor, clean the inner surface of the hole and apply solid lubricant paste → Parts catalogue. |
| 14 - | 8 Nm |
| q | For ABS revolution sensor |
