seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Hydraulic system > < Removing and installing vacuum senderG608

Leon Mk2

Removing and installing brake light switchF
Removing and installing brake light switch -F-
Removal:
–  Note or request radio code on vehicles with coded radio if necessary.
–  Disconnect battery → Electrical system; Rep. gr.27.
–  Remove air intake hose, air filter housing and battery. → Electrical system; Rep. gr.27
–  Remove battery tray.
   
–  Separate connector -1- from brake light switch -F-.
–  Remove bolt -2- from brake master cylinder.
–  Pull brake light switch -F--3- off the brake master cylinder at top and out of the clip at the bottom.
Installation
–  Installation is carried out in reverse order.
  N46-10099
Tightening torque: 
Torx bolt to brake master cylinder8 Nm

   

Hydraulic system > < Removing and installing vacuum senderG608