Leon Mk2
| FN 3 brake calliper - general assembly overview |
| t | When carrying out repairs, install all parts supplied in repair kit. |
| t | Use only methylated spirits to clean the brake caliper |
| t | Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals. |
| 1 - | Grease cap |
| q | Fit onto bleeder valve |
| 2 - | Bleeder valve, 10 Nm |
| q | Apply thin coat of assembly paste G 052 150 A2 to thread before screwing in. |
| 3 - | Hoods |
| q | Insert into sleeve bearing. |
| 4 - | Guide pin, 30 Nm |
| 5 - | Mounting bush |
| q | Insert in brake calliper |
| 6 - | Brake caliper |
| 7 - | Brake back plate |
| q | Bolt onto brake caliper. |
| 8 - | Retaining spring |
| q | Insert with both ends in holes in brake caliper. |
| 9 - | Seal |
| q | removing and fitting → Chapter |
| 10 - | Piston |
| q | removing and fitting → Chapter |
| q | Apply thin coat of assembly paste G 052 150 A2 to piston before inserting. |
| 11 - | Protective cap |
| q | removing and fitting → Chapter |
| q | Take care not to damage when inserting piston. |
