seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Fault indication via the Dual curcuit brake/handbrake warning lamp K7 and ABS warning lamp K47 > < Notes for repair work on ABS, ABS/EDL
Electrical/electronic components and fitting locations
   
Electrical/electronic components and fitting locations
1 - ABS hydraulic unit -N55-
q   Location: on left in engine compartment.
q   In the hydraulic unit, the ABS hydraulic pump -V64- and the intake/exhaust valves are checked via self-diagnosis
q   ABS hydraulic pump -V64- and valve block must not be separated from one another.
q   Removing and installing → Chapter.
2 - Control unit for ABS with EDL -J104-
q   Location: on hydraulic unit on left of engine compartment
q   Do not disconnect multi-pin connector before self-diagnosis has been completed. Switch ignition off before separating connector.
q   Removing and installing → Chapter.
3 - Brake light switch -F-
q   The brake light switch is open in the rest position
q   Adjusting brake light switch → Chapter.
4 - Dual circuit brake/handbrake warning lamp -K7-
q   Location: in dash panel insert.
5 - ABS warning lamp -K47-
q   Location: in dash panel insert.
6 - Speed sensor rotor
q   Rear right and left rotor and speed sensor are common parts → Running gear, axles, steering; Front and four-wheel drive; Rep. Gr.42
7 - Speed sensor rotor
q   Front right and left rotor and speed sensor are common parts
q   Removing and installing → Running gear, axles, steering; Front and four-wheel drive; Rep. Gr.40
8 - Rear right speed sensor -G44- / rear left speed sensor -G46-
q   Removing and installing → Chapter.
9 - Front right speed sensor -G45- / front left speed sensor -G47-
q   Removing and installing → Chapter.
10 - Diagnostic connection
q   Location: Under centre console.

   

Fault indication via the Dual curcuit brake/handbrake warning lamp K7 and ABS warning lamp K47 > < Notes for repair work on ABS, ABS/EDL