seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Rear revolution sensor cables: removal and fitting (vehicles with drum brakes up to 09.00) > < III - ABS system components on the rear axle: removal and fitting (vehicles with drum brakes from 09.00)

Leon Mk2

Revolution sensor, rear axle: removal and fitting (vehicles with drum brakes up to 09.00)
Revolution sensor, rear axle: removal and fitting (vehicles with drum brakes up to 09.00)
Special tools and workshop equipment required
   
t  Torque wrenches -SAT 8010-
Removing
Observe instructions for ABS repairs → Chapter.
–  Raise the vehicle.
  W00-2760
–  Disconnect revolution sensor cable -1- from revolution sensor.
–  Remove Allen bolt -2- from the axle stub casing.
–  Remove the revolution sensor from the axle stub.
Installation
–  Before fitting the revolution sensor the sensor housing must be cleaned and lubricating pase G 000 650 should be applied to the whole of the sensor.
–  Fit the revolution sensor into the wheel bearing casing orifice and tighten the Allen bolt. Tightening torques: 8 Nm
–  Connect the revolution sensor cable.
  N45-0117

Rear revolution sensor cables: removal and fitting (vehicles with drum brakes up to 09.00) > < III - ABS system components on the rear axle: removal and fitting (vehicles with drum brakes from 09.00)