seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Dismantling and assembling drive shaft with VL107 constant velocity slip joint > < Tripod type joint AAR 3300 i: assembly

Leon Mk2

Assembly overview for the VL107 constant velocity slip joint
   
Assembly overview for the VL107 constant velocity slip joint
1 - Outer constant velocity joint
q   Always replace completely
q   Removing → Fig.
q   Installing: slide onto the half shaft to the limit by tapping with a plastic mallet
q   check → Chapter
2 - Bolt.
q   Different versions available
q   Assignment → Electronic parts catalogue „ETKA“
  WARNING
t  There are two versions of the twelve-point head bolt, with and without ribbing. Distinguishing feature → Fig..
t  When installing a twelve-point head bolt, always note which version is being installed.
t  The respective specified torque must also be used.
t  The specified torque for twelve-point head bolts »without« ribbing is 70 Nm + 90° when loosening and tightening → Chapter.
t  The specified torque for twelve-point head bolts »without« ribbing is 200 Nm + 180° when loosening and tightening → Chapter.
q   Always renew if removed
3 - Circlip
q   Always renew if removed
q   Insert in groove in shaft
4 - Clamp
q   Always renew if removed
q   Tightening → Fig.
5 - Boot
q   Check for splits and chafing
q   Material: Hytrel (polyelastomer)
6 - Clamp
q   Always renew if removed
q   Tightening → Fig.
7 - Drive shaft
8 - Clamp
q   Always renew if removed
q   Tightening → Fig.
9 - Boot for constant velocity slip joint
q   Material: Hytrel (polyelastomer)
q   Without breather hole
q   Check for splits and chafing
10 - Circlip
q   Always renew if removed
q   Insert in groove in shaft
11 - Clamp
q   Always renew if removed
q   Tightening → Fig.
12 - Constant velocity slip joint
q   Always replace completely
q   Removing → Fig.
q   Installation: slide onto the half shaft to the limit by tapping with a plastic mallet
13 - Deflector cap
q   Remove → Fig.
q   Pressing on → Fig.

   
Distinguishing features between twelve-point head bolt with ribbing and twelve-point head bolt without ribbing.
The twelve-point head bolts can be distinguished by the contact surfaces -arrow A- and -arrow B-.
I - Twelve-point head bolt with ribbing -arrow A-
II - Twelve-point head bolt without ribbing -arrow B-
  N40-10569

Dismantling and assembling drive shaft with VL107 constant velocity slip joint > < Tripod type joint AAR 3300 i: assembly